11D-395000-03

Mini Simple Digital

About Your Watch

This digital watch will perform the following functions: Time, Date, Seconds.

Congratulations on purchasing your TIMEX® watch. Please read these instructions carefully to understand how to operate your Timex timepiece. For more information, please visit Timex.com.

Water and Shock Resistance

If your watch is water-resistant, meter marking or (Water resistance wave mark) is indicated.

Water-Resistance Depth p.s.i.a.* Water Pressure Below Surface
30m/98ft60
50m/164ft86
100m/328ft160

*pounds per square inch absolute

Operation and Setting

Operation

Digital watch face diagram labeled MODE (A) and RESET (B) buttons
  • Press the MODE (A) button to move from time to date.
  • Press the MODE (A) button again to move from date to seconds.
  • Press the MODE (A) button again to move from seconds back to time.

Setting

  • Press the RESET (B) button twice to enter the setting mode. The month will be displayed.
  • Press the MODE (A) button to advance the number to the correct month.
  • Press the RESET (B) button again to display the day of the month.
  • Press the MODE (A) button to advance the number to the correct day of the month.
  • Press the RESET (B) button again to display the hour.
  • Press the MODE (A) button to advance the number to the correct hour (A = AM, P = PM).
  • Press the RESET (B) button again to display the minutes.
  • Press the MODE (A) button to advance the number to the correct minutes.
  • Press the RESET (B) button again to exit the setting mode.

How to Adjust Bracelet

Variations of the following bracelet sections apply to all watch models.

Sliding Clasp Bracelet

Locking plate on sliding clasp bracelet being opened with a pointed tool
  1. Open locking plate.
  2. Move clasp to desired bracelet length.
  3. Exert pressure while holding locking plate and slide clasp back and forth until it engages in grooves on underside of bracelet.
  4. Press locking plate down until it snaps closed. Clasp can be damaged if excessive force is used.

Foldover Clasp Bracelet

Pointed tool pushing in the spring bar to disengage the foldover clasp bracelet
Fig. 1.
Spring bar being aligned with the correct hole in the bracelet band
Fig. 2.
Foldover clasp bracelet fully closed and locked in place after release
Fig. 3.
  1. Find spring bar that connects bracelet to clasp.
  2. Using a pointed tool, push in spring bar and gently twist bracelet to disengage.
  3. Determine wrist size, then insert spring bar in correct bottom hole.
  4. Push down on spring bar, align with top hole and release to lock in place.

Re-Assembly

Bracelet link pin being pushed back in the opposite direction and pressed flush into the bracelet
  1. Rejoin bracelet parts.
  2. Push pin back into link in opposite direction of arrow.
  3. Press pin down securely into bracelet until it is flush.

Battery

The watch button cell or coin battery is not intended to be replaced by a consumer. Only a jeweler or other professional is to replace the battery.